Calibration
-
Best Nozzle Temperature for PETG by Brand and Hotend
Start PETG at 240C, then run a 230-250C tower in 5C steps. Datasheet ranges, PTFE hotend limits and strength data tell you where to land.
-
FDM Print Stringing: How to Stop It in Four Steps
Stop FDM print stringing in four steps: dry the spool, drop nozzle temp 5-10 °C, tune retraction with a tower, then fix travel and wipe settings.
-
Orca Slicer Calibration Order: All 9 Tests in Sequence
Run Orca Slicer's nine built-in calibration tests, follow the documented sequence for the core five, and save each result to the correct profile.
-
How to Level a 3D Printer Bed Manually — Step-by-Step
Manual bed leveling sets up every good first layer. Walk through the paper method, the right corner order, and how many passes it actually takes.
-
3D Printer Temperature Tower & Flow Calibration
Run a temperature tower first, tune flow with a single-wall or slicer test, verify with a 20 mm cube, and save a profile for each filament spool.
-
Best Orca Slicer Settings: 12 Values That Matter
Start with 0.2 mm layers, 2–4 walls, 15–40% infill and 30–50 mm/s outer walls, then calibrate temperature, flow and pressure advance.
-
First Layer Calibration: Z-Offset, Leveling, and Flow
The first layer determines whether a print succeeds or fails. Here's how to calibrate z-offset, bed leveling, and flow rate to get it right every time.